Large Crown Iron-on - A/B iridescent Sequins

Description

Large A/B Iridescent Sequin Crown Iron-on Transfer
Size: 7” x 10”
Easy iron-on design.
Instructions:
Easy, DIY Iron on transfer
INSTRUCTIONS
Turn iron on high heat or Wool setting. DO NOT USE STEAM
1. Lay out and smooth your garment. If applying to apparel, make sure to place cardboard or other hard flat surface on the inside of your shirt between the front and back so the melted glue will not glue the front and back of your shirt together. A non-stick pressing cloth is preferred. (available at Joanne’s or Michaels).
2. Peel off white backing and place sticky side down onto fabric and position the design. Use tweezers to fix any overturned or out of place sequins.
3. Place iron on top of clear plastic cover sheet and hold for a minimum of 30-45 seconds. Do not move or wiggle around the iron. If design is larger than iron, pick up the iron and place it down on the next section until entire surface and glue has been melted. Don't worry about overlap.
4. Let plastic cool for approximately 1 minute. There should be a slight ripple or bubbling in the plastic. Slowly lift plastic off one corner. If there are sequins still sticking to the clear plastic, you have missed a section, OR you haven’t applied the iron long enough to melt all the glue. If this is the case, place plastic back down and heat with iron again until all glue is melted.
When cooled, peel off outer plastic and you’re done!
Additional Tips & Care Instructions: A
Turn garment inside out when laundering to help preserve design. Or, hang dry.
Thank you!
Condition is New. Shipped with USPS First Class Package.